Home Is Where The Smart Is

Buy my Wi-Fi controllers now

HIWTSI

NO-USB Tiny WLED controller (Wi-Fi/MQTT/Home Assistant)

Buy

HIWTSI

USB-A Mini WLED controller (Wi-Fi/MQTT/Home Assistant)

Buy

HIWTSI

USB-C Mini WLED controller (Wi-Fi/MQTT/Home Assistant)

Buy

HIWTSI

USB-C Plus WLED controller (Wi-Fi/MQTT/Home Assistant/Relay/IR Receiver)

Buy

Recommended compatible LED Strips and accessories

WS2811/12B RGBIC Addressable Seed Pixel Christmas Lights

Buy

Aroidful

3 PIN LED Strip Connectors 10mm

Buy

BTF-LIGHTING

1m WS2812E eco RGB addressable high density LED strip

Buy

BTF-LIGHTING

5m 5V addressable LED strip

Buy

BTF-LIGHTING

5m 5V RGBW addressable LED strip

Buy

Huudngeje

ESP32-CAM-MB

Buy

ruimeimei

WS2811 Addressable Waterproof RGB LED String Lights

Buy

Tesfish

5m 12V WS2811 addressable LED diffused rope strip

Buy

TOPXCDZ

5m 5V RGBW addressable LED strip

Buy

Install the WLED app on your phone

Download the WLED app onto you device from the relevant app store.

Install on iOS

Install on Android

Flash WLED onto our controllers

🚥 Go to this page

Plug your board into your computer
Select the version your wish to flash labelled "ESP32-S3 (4MB Flash)"
Click Install button and accept the popup and click the button again
Select the board from the next popup window, likely starting "USB JTAG" and click "Connect";
Then select "INSTALL WLED (ESP32-S3, 4MB)" and wait for it to finish, then unplug it and you are good to go!

This is a development board, not a finished product. So we assume you have some basic electrical understanding when purchasing and using this product, however below are some key points you need to bear in mind when using this product.

The amount of power required to run the controller and attached strip will vary GREATLY depending on the number of LEDs in the strip and it's operating voltage. e.g. for up to roughly 60 LEDs you can probably get away with powering the controller just from a higher end USB-C charger, but for more than this you may need to inject power from both ends of the strip to avoid voltage drop for longer lengths.
If you run more than 100 about LEDs or you opt for a higher voltage strip, you will need to get a dedicated power supply. At this point you can power the strip via the included power tails (typically red and white wires separate to the 3 wired into the board) and then leave the USB-C port unplugged, because the board will power itself from the power to the strip, and will work for just about any voltage strip you choose (4-36v).